case

YOUR POSITION:Home > News

How to Adjust the Break for Anode Jacking System

2017-07-07 15:18:37

How to Adjust the Break for Anode Jacking System

1.After 4 months use of the anode jacking system, the break will not work well due to the enlarged break clearance as the worn break pad.

2.Loose the socket bolt 1 with 8mm socket head wrench counterclockwise; loose nut 2 counterclockwise with 19 open-end wrench.

3.Turn the socket bolt 1 with 8mm socket head wrench clockwise, adjust the distance between break magnetic 3 and break disc 4 to make it within 1mm evenly.

4.After adjust the distance, turn the lock nut 2 clockwise with 19 open-end wrench and at the same time watch the distance between the break magnetic 3 and break disc 4 to make sure the distance is within 1mm evenly at 4 points.

5.Turn on the electricity and watch if the break disc works smoothly.

Adjust the Break for Anode Jacking System

Pre: Anode Yoke Is Widely Used In Electrolytic Aluminum Industry Next:The Electrolytic Aluminum Supply-side Structural Reform Curtain Opening

INQUIRY

  • Name:
  • *E-mail:
  • *Message:
  • CONTACT US

    • +86 (0) 371 5517 8216
    • jodatech@joda-tech.com
    • +86 15729398216
    • Shenglong Plaza, The crossing of Dongfeng South Road and Dongzhan South Road, Zhengdong New District, Zhengzhou, China.

    Copyright @ 2017 ZhengZhou Joda Technology Co., Ltd. All Rights Reserved

    Technical Support:Joda   sitemap